router

Flashing bricked TP-LINK AC1200 Archer C5 v1.20 using JTAG cable

  • Posted on: 19 September 2015
  • By: Michał Turecki

Here is a short list of steps involved.

  1. Connect JTAG cable to 3.3V capable serial interface.
  2. Make sure that cable has TX and RX swapped and only GND is connected, VCC should not be.
  3. Run putty or other terminal software. Use baud rate 115200, 8 data bits + 1 stop bit, no parity or flow control